transmitter for a power screen commander 510

Transmitter for a power screen commander 510 generator#

Output of the MOS-FET power amplifier stage. Digital PWM techniques provide an easily adjustable and accurate automatic level controlled R.F. Its broadband “no-tune” design allowsĨ7.5-108 MHz operation from internal direct reading rotary switches or the front panel LCD frequency control system if enabled. The BW Broadcast TX 600 is a high specification FM broadcast transmitter. Connecting a re-broadcast or STL receiver to the transmitter.Ĭonsult the manual for further information on the transmitter’s jumpers and connections.

Transmitter for a power screen commander 510 generator#

Connecting an external audio processor or stereo generator to the.Routing the internal MPX signal through an external RDS encoder.Need to move J1 (MPX loop-through) to the OFF position.Įxamples of configurations requiring setting J1 to OFF include: If you intend to connect a MPX signal to the MPX input BNC connector you will Internal jumper J1 (MPX loop-through) is set to ON. This transmitter has been shipped with the internal stereo generator enabled. This transmitter should never be operated without a suitable antenna or test dummy load! Failure to observe this requirement may result in damage to the transmitter that is not covered by the warranty.

The information and specifications contained in this document is subject to change at any time without notice. No part of this manual may be re-produced in any form without prior written permission from Broadcast Warehouse.